|
How
to Tie a Full Windsor Knot
This
knot requires the most amount of material to tie. It is best
used with relatively thin tie fabric.
How
to Tie a Half Windsor
How to Tie a Tie
 |
Start with the wide
end of the tie on your right side. Extend the wide end
approximately a foot below the narrow end.
|
 |
Cross the wide end
of the tie over the narrow end and bring the wide end up through
the loop. |
 |
Cross the wide end
over the narrow end and bring the wide end up through the
loop. |
 |
Wrap the wide end
around the front of the tie as shown. |
 |
After wrapping around
the front of the tie, bring the wide end up and through the
loop. If done correctly, the knot will resemble a triangle
when tightened. |
 |
Complete by putting
the wide end of the tie down through the knot in the front.
Tighten the knot by pulling on the wide end of the tie while
holding the knot. To draw up the knot snug to the collar
pull on the narrow end of the tie while holding the knot. |
|
